Is there such a variable? Relative E values would also work, but Cura only uses absolute values. But I am not sure if Cura can do this: I think of something like G92 E up). I think a command in the PostSwitchExtruder.gcode setup section could help. This leads to a heap of material at or nearby the position where the tool change command has taken place. I assume that because of the tool (extruder) change command, the newly chosen extruder needs to catch up with the amount of material that has just been printed before (because the extrusion value has gotten this big). My printer then spits out huge amounts of the material that has been switched to. tool change, then the extruder value (Exx.xx) just continues counting upwards from the old extruder's value. My problem is: When Cura V15.04.6 writes an M135 Tx (x=0 or 1) command, i. Download it now and get the most modern 3D printing workflow available. ![]() I want to print soluble support material (PVA) with the second extruder. Download now All of these features and more are available in Ultimaker Cura 4.3 today. I am trying to generate GCode and then convert it with GPX into an X3G file. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |